For technical reasons it is impossible to guarantee a perfect colour match between samples and stocked articles, or between different fabric lots and coordinated articles. Whenever a perfect match is required, it is recommended to ask for a stock cutting before confirming an order. It will not be possible to supply a stock sample for wallpapers and for some other items listed in the price list.

From one fabric lot to another, width measurement and repeat may differ slightly from those indicated in our price lists and on our samples. Any such fluctuation, if within a limit of 3%, will not be considered a valid cause for a claim. It is advised to specify the number of repeats required whenever there is a close relationship between the yardage ordered and the fabric repeat. Concerning printed, embroidered or flocked fabrics, the width shown on our price list refers to that of the print (useable width) and not that of the fabric ground which can vary without giving rise to disputes.

With regards to moiré fabrics, a variation of 5% in length can be considered normal. Within these limits no claim can be acknowledged. It is advised to bear these indications and margins in mind when calculating the measurements of finished curtains and hems, in order to avoid subsequent claims. For water washable fabrics please see the dedicated paragraph “Care Instructions”.

Dedar’s fabrics, trimmings and wallpapers are produced according to state-of-the-art manufacturing techniques which fully comply with requirements of light-fastness as well as current environmental and health regulations. However, fading may occur in particular atmospheric conditions or in the case of excessive exposure to sunlight or halogen lamps. A slight loss of colour may be caused by rubbing in the case of dark-coloured fabrics. Lining is recommended, particularly when making up silk fabrics intended for exposure to direct sunlight.

Variations on fabric pattern repeats may occur. While estimating the pattern repeats and before upholstering, it is recommended to be sure that repeats and alignments are commensurate to the expected output. Since it is technically impossible to guarantee a perfect horizontal alignment in fabrics with a pattern repeat, it is recommended to take this into account when making up blinds and panels or in wall covering applications.

When used for seating upholstery, the pile of velvet or chenille fabrics tends to flatten slightly causing the finish to reflect the light differently and produce a so-called “shading” effect. This is a typical characteristic of such fabrics and does not depend on any manufacturing defect, neither can it be considered the object of any claim. Particular care should be taken in storing velvet fabrics, making sure these are hung and kept in a horizontal position.

It is entirely up to the customer to indicate the right side to the upholsterer on having reversible fabrics made up.

It is recommended that the fabric be stretched in the direction of the warp. Particularly in the case of natural fibers such as cotton and linen, if the fabric is not sufficiently smoothed out in the direction of the warp, it may in fact swell up in certain weather conditions. Any responsibility will be declined in the event of swelling or creases in the fabric caused by negligence in following the above instructions.

Most extra-wide fabrics may be used in either direction. It is recommended to check the direction required beforehand and calculate the resulting yardage needed for the project, bearing in mind the pattern direction and repeat.

Apart from rare occasions, in which the customer is warned beforehand, for shipping purposes the fabric is folded in layers to prevent permanent creases forming at the centre of the fabric length. This procedure has been specially devised for each individual fabric type in order to reduce the risk of damage to an absolute minimum.

For fabric lengths exceeding 10 m and for some destinations, it is possible to ship the fabric rolled on full-width bales. Such solution, however, entails higher transport costs and longer delivery times.

For technical reasons, extra-wide stripes tend to curve at the centre. This effect is due to yarn tension and cannot be avoided. It is recommended the maximum caution, therefore, when making up Roman blinds or curtain panels.

Indications are given in our price lists of the following fabrics and wallpapers:

• Permanently fire-retardant fabrics.
• Permanently fire-retardant wallpapers. 

On request, it is possible to effect fire retardancy and non-soil treatments on most of our fabrics. The company cannot accept any liability with regards to the result of any such treatment or for any alteration in the fabric hand and appearance once the fabric has been treated, which must be considered quite normal. Please contact the Dedar commercial offices (contract@dedar.com) for further information on fire retardancy treatments and the development of special products.

When washing fabrics in water, we recommend the use of sanitizing detergents and a temperature of 30° C. The sanitizing effect obtainable from low concentrations such as these may vary according to the type and composition of the fabric, and therefore vary in effectiveness. The fabric type, composition, colour, and cleansing action could tend to alter the appearance and tone of the colour, or even cause the formation of water stains.

We advise you to clean non-washable fabrics using a damp cloth soaked in bleach or ethyl alcohol diluted in water in a low concentration (5-10%). The sanitizing effect obtainable from low concentrations such as these may vary according to the type and composition of the fabric, and therefore vary in effectiveness. The fabric type, composition, colour, and cleansing action could tend to vary the appearance and tone of the colour or even cause the formation of water stains.